KFD0-CS-2.50, Repeater

KFD0-CS-2.50, RepeaterRepeater, KFD0 CS 2. 50 2 channel signal conditioner 24 V DC supply (loop powered) Current input output 4 mA 20 mA transmitter power supply Accuracy 0. 1 % Reverse polarity protection Up to SIL 2 acc. to IEC EN 61508 This signal conditioner provides the galvanic isolation between field circuits and control circuits. The device can be used as a repeater or transmitter power supply for 2 wire transmitters. This device is loop powered. No additional

Suitable for Power Rail UPR-**-*

TPH-LBF-IA1

This module mounts on a HiD Termination Board

rated insulation voltage 300 Veff Indicators/settings Display elements LEDs Control elements DIP-switch Configuration via DIP switches Labeling space for labeling at the front Directive conformity Electromagnetic compatibility Directive 2014/30/EU EN 61326-1:2013 (industrial locations) Low voltage Directive 2014/35/EU EN 61010-1:2010+A1:2019+A1:2019/AC:2019 Conformity Electromagnetic compatibility NE 21:2017

This device mounts on a HiD Termination Board

Compact and space-saving design

000 m Relative humidity (% RH operating without condensation) Non condensing

Zone 1/2/22

24 VDC supply  (loop powered)

Via switches the mode of operation can be reversed and the line fault detection can be switched off

The module reads the variables from the instrument and converts these to dynamic variables on Profibus

Designed for calibration professionals