CytoCure DA-4

CytoCure DA-4CytoCure DA 4 is a one part hydrophobic and modestly oleophobic coating formulated for metals and plastic. CytoCure has excellent resistance to paste, solvents and abrasion when applied to metals, plastics or glass. CytoCure is UV light resistant and prevents oxidative damage of coated substrates. CytoCure can be applied by simple wipe on methods. When well cured (baked at 60 100C), contact angles to water greater than 100 and roll off angles of less

have contact angles to water in excess of 140° and have great chemical and solvent resistance

Thin films cure by ramping heat from ambient to 200°C and maintain at 200°C for 20 minutes

Application: Sand the surface with 220 grit sandpaper using a circular motion and wipe-down with Isopropyl Alcohol to eliminate all sanding residue and dry

FluoroPel PFC110 is a fluoro-solvent for diluting FluoroPel

MicroCure DTO-LF is a hydrophobic and oleophobic conformal coating

FluoroPel 2000V is a one percent fluoropolymer solution in a high boiling point fluorosolvent (BP=200°C)

air-cured coating formulated for spray

the surface must be sanded

Add the crushed pellets of 100LC to fluorosolvent slowly (0

CytoCure can be applied by dipping

s (at 25°C)

Spray Directions: Surface should be clean