Replacement LCD, Interface and Controller

Replacement LCD, Interface and ControllerSafe and precise power output. This touchscreen is the replacement part for the wall mounted BREWHA Touchscreen Electric Brewing Power Controllers. Note: when installing, hand tighten bezel screws only until snug and do not overtighten (do not use a drill) or the screen might crack. Note: replacement interfaces are shipped without micro SD cards; these should be transferred over from existing controller assemblies The WiFi Module attaches to Gen 2

These glycol chillers delivers reliable performance in both 1/3hp (3600BTU/1060W cooling) and 3/4hp (7200BTU/2130W cooling) configurations

With a heat exchanger (unlike the spray method of other commercial condensers) the cooling water stream is not mixed with the brew vapor (and does not therefore contain any undesirable compounds such as DMS that are being removed from the wort)

Liquid volume per side: 9L

Note: Use only with clean water at temperatures between 2°C/ 36°F and 40°C/ 100°F

The fitting has a sturdy lever that can be used to rotate the arm downward (loosen the clamp just slightly) until it starts to pick up yeast that has settled at the bottom of the fermenter

or debris before installing the replacement impeller

They pair well with BREWHA brewery pumps and transfer equipment

BREWHA’s Cold Liquor Water Tank is built for breweries that need a reliable source of pre-chilled water for post-boil knockdown and other brewery cooling applications

ensuring efficient connections and optimal performance during brewing processes

Water should always be unrestricted and free flowing into the pump through a 3/4" or greater diameter hose

Sanitary temperature sensors thermostat and sensor cable can be added separately to the cart as needed (typically one sensor product per tank and one cable product per controller)

consistent hard seltzer for pilot and commercial production